![]() ![]() Please make sure to verify these value to be the same at your switch. The port and timeout assmed in the above steps are 635. > sflow sampler 1 2/1-5 receiver 1 rate 2048 sample-hdr-size 128 The following configuration enables sFlow monitoring of all interfaces on an Alcatel-Lucent OmniSwitch switch (10.0.0.235), sampling packets at 1-in-512, polling counters every 30 seconds and sending the sFlow to an analyzer (10.0.0.1) on UDP port 6343 (the default sFlow port).See Trying out sFlow for suggestions on getting started with sFlow monitoring and reporting. ![]() SFlow sampler instance 1 on ports 2/1-5, enter: ![]() For example, to specify the sample-hdr-size value "128" for > sflow sampler 1 2/1-5 receiver 1 rate 2048Ģ. The OmniSwitch 6850E is available in 24- and 48-port configurations and provides wire-rate layer-2 and layer-3 switching simultaneously for IPv4 and IPv6. > sflow receiver 1 name Golden address CCE_IP_Addressįollow the steps below to create a sFlow sampler session.ġ.To create a sFlow sampler session, use the sflow sampler command by entering sflow sampler, followed by the instance ID, port list, receiver, and the rate. The new Alcatel-Lucent OmniSwitch 6850E Stackable LAN Switch (SLS) is the latest advanced stackable gigabit Ethernet switch in the OmniSwitch family of products. To create a sFlow receiver session, use the sFlow receiver command by entering sflow receiver, followed by the receiver index, name, and the address to be monitored. Follow the steps below to create a sFlow receiver session. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |